SMJ27C010A 131072 BY 8-BIT UV ERASABLE PROGRAMMABLE READ-ONLY MEMORY

SMLS858A - AUGUST 1996 - REVISED SEPTEMBER 1997

Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of TexasInstruments semiconductor products and disclaimers thereto appears at the end of this data sheet.

features

Organization...131072 by 8 Bits
Single 5-V Power Supply
Operationally Compatible With Existing Megabit EPROMs
Industry Standard 32-Pin Ceramic Dual-In-line Package (J Suffix)
All Inputs/Outputs Fully TTL-Compatible
Maximum Access/Minimum Cycle Time
V_CC ± 10%
'27C010A-12 120 ns
'27C010A-15 150 ns
'27C010A-20 200 ns
8-Bit Output for Use in Microprocessor-Based Systems
Very High-Speed SNAP! Pulse Programming
Power-Saving CMOS Technology
3-State Output Buffers
400-mV Minimum DC Noise Immunity With Standard TTL Loads
Latchup Immunity of 250 mA on All Input and Output Pins
No Pullup Resistors Required
Low Power Dissipation (V_CC = 5.5 V)
- Active...165 mW Worst Case
- Standby...0.55 mW Worst Case (CMOS-Input Levels)

description

The SMJ27C010A series are 131072 by 8-bit (1048576-bit), ultraviolet (UV) light erasable, electrically programmable read-only memories (EPROMs).

These devices are fabricated using power-saving CMOS technology for high speed and simple interface with MOS and bipolar circuits. All inputs (including program data inputs) can be driven by Series 54 TTL circuits without the use of external pullup resistors. Each output can drive one Series 54 TTL circuit without external resistors.

The SMJ27C010A EPROM is offered in a ceramic dual-in-line package (J suffix) designed for insertion in mounting-hole rows on 15,2-mm (600-mil) centers.

These EPROMs operate from a single 5-V supply (in the read mode), and therefore, are ideal for use in microprocessor-based systems. One other 13-V supply is needed for programming. All programming signals are TTL level. These devices are programmable using the SNAP! Pulse programming algorithm. The SNAP! Pulse programming algorithm uses a V_PP of 13 V and a V_CC of 6.5 V for a nominal programming time of thirteen seconds. For programming outside the system, existing EPROM programmers can be used. Locations can be programmed singly, in blocks, or at random.

Title: 131072 BY 8-BIT UV ERASABLE PROGRAMMABLE READ-ONLY MEMORY
Product Family: EPROM
Device Functionality: EPROM-1M(128KX8)
Orderable Devices: SM27C010A-20JM, SMJ27C010A-12JM, SMJ27C010A-15JM, SMJ27C010A-20JM

View the complete PDF datasheet: smls858a.pdf (148 K Bytes) (Requires Acrobat Reader 3.x)

View more information about generic part numbers:SMJ27C010A

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.