TPS7301Q, TPS7330Q, TPS7333Q, TPS7348Q, TPS7350Q LOW-DROPOUT VOLTAGE REGULATORS WITH INTEGRATED DELAYED RESET FUNCTION

SLVS124E - JUNE 1995 - REVISED APRIL 1997

features

Available in 3-V, 3.3-V, 4.85-V, and 5-V Fixed-Output and Adjustable Versions
Integrated Precision Supply-Voltage Supervisor Monitoring Regulator Output Voltage
Active-Low Reset Signal with 200-ms Pulse Width
Very Low Dropout Voltage . . . Maximum of 35 mV at I_O = 100 mA (TPS7350)
Low Quiescent Current - Independent of Load . . . 340 uA Typ
Extremely Low Sleep-State Current, 0.5 uA Max
2% Tolerance Over Full Range of Load, Line, and Temperature for Fixed-Output Versions
Output Current Range of 0 mA to 500 mA
TSSOP Package Option Offers Reduced Component Height For Critical Applications

description

The TPS73xx devices are members of a family of micropower low-dropout (LDO) voltage regulators. They are differentiated from the TPS71xx and TPS72xx LDOs by their integrated delayed microprocessor-reset function. If the precision delayed reset is not required, the designer should consider the TPS71xx and TPS72xx.^§

The RESET\ output of the TPS73xx initiates a reset in microcomputer and microprocessor systems in the event of an undervoltage condition. An internal comparator in the TPS73xx monitors the output voltage of the regulator to detect an undervoltage condition on the regulated output voltage.

If that occurs, the RESET\ output (open-drain NMOS) turns on, taking the RESET\ signal low. RESET\ stays low for the duration of the undervoltage condition. Once the undervoltage condition ceases, a 200-ms (typ) time-out begins. At the completion of the 200-ms delay, RESET\ goes high.

An order of magnitude reduction in dropout voltage and quiescent current over conventional LDO performance is achieved by replacing the typical pnp pass transistor with a PMOS device.

Because the PMOS device behaves as a low-value resistor, the dropout voltage is very low (maximum of 35 mV at an output current of 100 mA for the TPS7350) and is directly proportional to the output current (see Figure 1). Additionally, since the PMOS pass element is a voltage-driven device, the quiescent current is low and remains constant, independent of output loading (typically 340 uA over the full range of output current, 0 mA to 500 mA). These two key specifications yield a significant improvement in operating life for battery-powered systems.

The LDO family also features a sleep mode; applying a logic high signal to EN\ (enable\) shuts down the regulator, reducing the quiescent current to 0.5 uA maximum at T_J = 25°C.

The TPS73xx is offered in 3-V, 3.3-V, 4.85-V, and 5-V fixed-voltage versions and in an adjustable version (programmable over the range of 1.2 V to 9.75 V). Output voltage tolerance is specified as a maximum of 2% over line, load, and temperature ranges (3% for adjustable version). The TPS73xx family is available in PDIP (8 pin), SO (8 pin) and TSSOP (20 pin) packages. The TSSOP has a maximum height of 1.2 mm.

Title: LOW-DROPOUT VOLTAGE REGULATORS WITH INTEGRATED DELAYED RESET FUNCTION
Product Family: VOLTAGE REGULATORS
Device Functionality: VOLTAGE REGULATORS
Orderable Devices: TPS7301QD, TPS7301QDR, TPS7301QP, TPS7301QPWLE, TPS7330QD, TPS7330QDR, TPS7333QD, TPS7333QDR, TPS7333QP, TPS7333QPWLE, TPS7348QD, TPS7348QDR, TPS7348QP, TPS7348QPWLE, TPS7350QD, TPS7350QDR, TPS7350QP, TPS7350QPWLE

View the complete PDF datasheet: slvs124e.pdf (578 K Bytes) (Requires Acrobat Reader 3.x)

View more information about generic part numbers:TPS7301, TPS7330, TPS7333, TPS7348, TPS7350

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.