SLLS181 - DECEMBER 1994
The SN75185 combines three drivers and five receivers from TI trade-standard SN75188 and SN75189 bipolar quadruple drivers and receivers, respectively. The pinout matches the flow-through design of the SN75C185 to decrease the part count, reduce the board space required, and allow easy interconnection of the UART and serial-port connector of IBMTM PC/ATTM
IBM and PC/AT are trademarks of IBM Corporation. and compatibles. The bipolar circuits and processing of the SN75185 provides a rugged low-cost solution for this function at the expense of quiescent power and external passive components relative to the SN75C185.
The SN75185 complies with the requirements of the EIA/TIA 232-E and ITU (formerly CCITT) v.28 standards. These standards are for data interchange between a host computer and peripheral at signalling rates up to 20 kbit/s. The switching speeds of the SN75185 are fast enough to support rates up to 120 kbit/s with lower capacitive loads (shorter cables). Interoperability at the higher signalling rates cannot be assured unless the designer has design control of the cable and the interface circuits at both ends. For interoperability at signalling rates to 120 kbit/s, use of EIA/ITA-423-B (ITU v.10) and EIA/ITA-422-B (ITU v.11) standards are recommended.
The SN75185 is characterized for operation over the temperature range of 0°C to 70°C.
View more information about generic part numbers:SN75185
Go to the Engineering Design Center to locate information on other TI Semiconductor devices.