SN75ALS164 OCTAL GENERAL-PURPOSE INTERFACE BUS TRANSCEIVER

SLLS022B - JUNE 1986 - REVISED AUGUST 1989

features

• 8-Channel Bidirectional Transceiver
• Designed to Implement Control Bus Interface
• Designed for Multicontrollers
• High-Speed Advanced Low-Power Schottky Circuitry
• Low-Power Dissipation . . . 46 mW Max Per Channel
• Fast Propagation Times . . . 20 ns Max
• High-Impedance PNP Inputs
• Receiver Hysteresis . . . 650 mV Typ
• Bus-Terminating Resistors Provided on Driver Outputs
• No Loading of Bus When Device Is Powered Down (V_CC = 0)
• Power-Up/Power-Down Protection (Glitch Free)

description

The SN75ALS164 eight-channel general-purpose interface bus transceiver is a monolithic, high-speed, advanced low-power Schottky device designed to meet the requirements of IEEE Standard 488-1978. Each transceiver is designed to provide the bus-management and data-transfer signals between operating units of a multiple-controller instrumentation system. When combined with the SN75ALS160 octal bus transceiver, the SN75ALS164 provides the complete 16-wire interface for the IEEE 488 bus.

The SN75ALS164 features eight driver-receiver pairs connected in a front-to-back configuration to form input/output (I/O) ports at both the bus and terminal sides. All outputs are disabled (at a high-impedance state) during V_CC power-up and power-down transitions for glitch-free operation. The direction of data flow through these driver-receiver pairs is determined by the DC, TE, and SC enable signals. The SN75ALS164 is identical to the SN75ALS162 with the addition of an OR gate to help simplify board layouts in several popular applications. The ATN and EOI signals are ORed to provide the ATN + EOI output, which is a standard totem-pole output.

The driver outputs (GPIB I/O ports) feature active bus-terminating resistor circuits designed to provide a high impedance to the bus when supply voltage V_CC is 0. The drivers are designed to handle loads up to 48 mA of sink current. Each receiver features pnp transistor inputs for high input impedance and hysteresis of 400 mV minimum for increased noise immunity. All receivers have 3-state outputs to present a high impedance to the terminal when disabled.

The SN75ALS164 is characterized for operation from 0°C to 70°C.

View more information about generic part numbers:SN75ALS164

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.

(c) Copyright 1998 Texas Instruments Incorporated. All rights reserved.
Trademarks, Important Notice!