LM111, LM211, LM311, LM311Y DIFFERENTIAL COMPARATORS WITH STROBES

SLCS007A - SEPTEMBER 1973 - REVISED FEBRUARY 1992

features

Fast Response Times
Strobe Capability
Maximum Input Bias Current . . . 300 nA
Maximum Input Offset Current . . . 70 nA
Can Operate From Single 5-V Supply
Designed to Be Interchangeable With National Semiconductor LM111, LM211, and LM311

description

The LM111, LM211, and LM311 are single high-speed voltage comparators. These devices are designed to operate from a wide range of power supply voltages, including ±15-V supplies for operational amplifiers and 5-V supplies for logic systems. The output levels are compatible with most TTL and MOS circuits. These comparators are capable of driving lamps or relays and switching voltages up to 50 V at 50 mA. All inputs and outputs can be isolated from system ground. The outputs can drive loads referenced to ground, V_CC+ or V_CC-. Offset balancing and strobe capabilities are available, and the outputs can be wire-OR connected. If the strobe is low, the output will be in the off state regardless of the differential input.

The LM111 is characterized for operation over the full military range of -55°C to 125°C. The LM211 is characterized for operation from -40°C to 85°C, and the LM311 is characterized for operation from 0°C to 70°C.

Title: DIFFERENTIAL COMPARATORS WITH STROBES
Product Family: COMPARATORS
Device Functionality: SINGLE, HIGH SPEED, ST
Orderable Devices: JM38510/10304BPA, LM111FKB, LM111JG, LM111JGB, LM211D, LM211P, LM311D, LM311DR, LM311P, LM311PWLE, LM311Y

View the complete PDF datasheet: slcs007a.pdf (261 K Bytes) (Requires Acrobat Reader 3.x)

View more information about generic part numbers:LM111, LM211, LM311

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.