Texas Instruments
SemiconductorsSearchFeedbackTI Home
Engineering Design CenterDSP SolutionsSC in the newsSC Product InformationSC Applications & TechnologiesSC Service & Support

Data Sheet Abstract

SN74ALVC162334 16-BIT UNIVERSAL BUS DRIVER WITH 3-STATE OUTPUTS

SCES127A - FEBRUARY 1998 - REVISED MARCH 1998


features

description

This 16-bit universal bus driver is designed for 2.3-V to 3.6-V VCC operation.

Data flow from A to Y is controlled by the output-enable (OE\) input. The device operates in the transparent mode when the latch-enable (LE\) input is low. When LE\ is high, the A data is latched if the clock (CLK) input is held at a high or low logic level. If LE\ is high, the A data is stored in the latch/flip-flop on the low-to-high transition of CLK. When OE\ is high, the outputs are in the high-impedance state.

The outputs, which are designed to sink up to 12 mA, include equivalent 26-Ω resistors to reduce overshoot and undershoot.

To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.

The SN74ALVC162334 is characterized for operation from -40°C to 85°C.

Output level before the indicated steady-state input conditions were established


Title: 16-BIT UNIVERSAL BUS DRIVER WITH 3-STATE OUTPUTS
Product Family: UNIVERSAL BUS DRIVERS (UBDS)
Device Functionality: 16-BIT UNIVERSAL BUS DRIVER

View the complete PDF datasheet: sces127a.pdf (106 K Bytes) (Requires Acrobat Reader 3.x)

View more information about generic part numbers:SN74ALVC162334

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.

SemiconductorsSearchFeedbackTI Home
(c) Copyright 1998 Texas Instruments Incorporated. All rights reserved.
Trademarks, Important Notice!