SCBS207F - OCTOBER 1992 - REVISED MAY 1997
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of TexasInstruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
Widebus and EPIC-IIB are trademarks of Texas Instruments Incorporated.
The 'ABTH16460 are 4-bit to 1-bit multiplexed registered transceivers used in applications where four separate data paths must be multiplexed onto or demultiplexed from a single data path. Typical applications include multiplexing and/or demultiplexing of address and data information in microprocessor or bus-interface applications. These devices also are useful in memory-interleaving applications.
Five 4-bit I/O ports (1A-4A, 1B1-4, 2B1-4, 3B1-4, and 4B1-4) are available for address and/or data transfer. The output-enable (OEB\, OEB1\-OEB4\, and OEA\) inputs control the bus-transceiver functions. These control signals also allow 4-bit or 16-bit control, depending on the OEB\ level.
Address and/or data information can be stored using the internal storage latches/flip-flops. The latch-enable (LEB1-LEB4, LEBA, and LEAB1-LEAB4) and clock/clock-enable (CLK/CLKEN\) inputs are used to control data storage. When either one of the latch-enable inputs is high, the latch is transparent (clock is a don't care as long as the latch enable is high). When the latch-enable input goes low (providing that the clock does not transit from low to high), the data present at the inputs is latched and remains latched until the latch-enable input is returned high. When the clock enable is low and the corresponding latch enable is low, data can be clocked on the low-to-high transition of the clock. When either the clock enable or the corresponding latch enable is high, the clock is a don't care.
Four select pins (SEL0, SEL1, CE_SEL0, and CE_SEL1) are provided to multiplex data (A port), or to select one of four clock enables (B port). This allows the user the flexibility of controlling one bit at a time.
Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic level.
When VCC is between 0 and 2.1 V, the device is in the high-impedance state during power up or power down. However, to ensure the high-impedance state above 2.1 V, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
The SN54ABTH16460 is characterized for operation over the full military temperature range of -55°C to 125°C. The SN74ABTH16460 is characterized for operation from -40°C to 85°C.
View more information about generic part numbers:SN74ABTH16460
Go to the Engineering Design Center to locate information on other TI Semiconductor devices.