



SCAS317A - NOVEMBER 1993 - REVISED OCTOBER 1995
EPIC and Widebus are trademarks of Texas Instruments Incorporated.
This 16-bit registered transceiver is designed for low-voltage (3.3-V) VCC operation.
The SN74LVC16543 can be used as two 8-bit transceivers or one 16-bit transceiver. Separate latch-enable (LEAB\ or LEBA\) and output-enable (OEAB\ or OEBA\) inputs are provided for each register to permit independent control in either direction of data flow.
The A-to-B enable (CEAB\) input must be low in order to enter data from A or to output data from B. If CEAB\ is low and LEAB\ is low, the A-to-B latches are transparent; a subsequent low-to-high transition of LEAB\ puts the A latches in the storage mode. With CEAB\ and OEAB\ both low,
the 3-state B outputs are active and reflect the data present at the output of the A latches. Data flow from B to A is similar but requires using the CEBA\, LEBA\, and OEBA\ inputs.
To ensure the high-impedance state during power up or power down, OE\ should be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the driver.
Active bus-hold circuitry is provided to hold unused or floating data inputs at a valid logic level.
The SN74LVC16543 is characterized for operation from -40°C to 85°C
View more information about generic part numbers:SN74LVC16543
Go to the Engineering Design Center to locate information on other TI Semiconductor devices.



