74ACT11544 OCTAL REGISTERED TRANSCEIVER WITH 3-STATE OUTPUTS

SCAS133 - D3609, JULY 1990 - REVISED APRIL 1993

features

• Inputs Are TTL-Voltage Compatible
• 3-State Inverted Outputs
• Back-to-Back Registers for Storage
• Flow-Through Architecture Optimizes PCB Layout
• Center-Pin V_CC and GND Configurations Minimize High-Speed Switching Noise
• EPIC^TM (Enhanced-Performance Implanted CMOS) 1-m Process
• 500-mA Typical Latch-Up Immunity at 125°C

  EPIC is a trademark of Texas Instruments Incorporated.

description

This 8-bit registered transceiver contains two sets of D-typelatches for temporary storage of data flowing in either direction.Separate latch enable ( or) and outputenable ( or ) inputs are provided for eachregister to permit independent control in either direction of dataflow. The 74ACT11544 inverts data in both directions.

The A-to-B enable ()input must be low in order to enter data from A or to output data toB. Having low and low makes the A-to-B latchestransparent; a subsequent low-to-high transition of puts the A latches in the storagemode. With and both low, the 3-state B outputsare active and reflect the data present at the output of the Alatches. Data flow from B-to-A is similar, but requires the use of, , and inputs.

The 74ACT11544 is characterized for operation from -40°C to85°C.

View more information about generic part numbers:74ACT11544

Go to the Engineering Design Center to locate information on other TI Semiconductor devices.

(c) Copyright 1998 Texas Instruments Incorporated. All rights reserved.
Trademarks, Important Notice!