


        The TABLE program configures the various drivers and devices
      into the unit table. By default, the TABLE program tries to
      contact an SRM or SRM/UX server at host node number (or emulated
      host node number) 0 over a LAN or SRM card set at select code 21
      on the client workstation and configure volume 8 of this server
      into unit 5 in the unit table. Also unit 45 will be assigned to
      the directory WORKSTATIONS/SYSTEMnn, WORKSTATIONS/SYSTEMnnnnnn
      or WORKSTATIONS/SYSTEM relative to the root of volume 8 if this
      directory is present on the server.

        For the case where the Pascal client actually boots from the
      server, unit 5 will be assigned volume 8 on the server even if
      the server node number and client select code do not match the
      default values. Also unit 45 will be assigned as above only if
      it's associated directory is present. If the correct modules
      (DATA_COMM and SRM for SRM cable; IOMPX, LANDVR and SRM for LAN
      cable) are not present in INITLIB when booting unit 5 and unit
      45 will not be connected at all.
